You can cut out holes at the base for bottles, or you can use that space for names or a snowfill engraved message.

*updated 12/27/11



This single block design was published in a newsletter along with the martini glass design in 1998.

Obviously, with this sculpture, you have to be sure not to cut the stem of the glass down too much, or after a while, it won’t look like a champagne glass. The dotted lines in the sculpture (not the template grid) indicate cuts down into the ice. The sculpture should be cut so that the base of the sculpture (just below the glass) extends out toward the front. Then two holes can be cut into the base to hold bottles of champagne. You can use a special bit that attaches to a drill to cut these holes. The dotted lines in the glass itself indicates how the top can be hollowed out if desired.


Make cutting out the holes for bottles easier by using a specialty 4" hole-cutting drill bit.



If you have any questions about this piece, email me or comment below. If you would like to use this ice sculpture design or any other design on this site, please check the design usage guidelines. The design collection page lists designs on the site.

You might also find photos and info from this entry on the ice carving secrets facebook page and you can comment there as well as below. Thanks!

Tags: New Year's Eve, weddings, champagne, bottle holder